Publicidad
Idiomas disponibles
Idiomas disponibles
REPROGRAMMING REMOTE TRANSMITTERS (continued)
SRE-3000 INSTALLATION 02-08-2019
7. Release both buttons (LEARN/ERASE and
one on remote).
The remote is now programmed .
8. Make sure all remotes are set to same
dip switch configuration.
NOTE: It is only necessary to program
one remote if all remote dip
switches are set the same .
9. Test transmitter operation:
• Press either button on remote.
• If carriage moves, new settings been
accepted and remote is programmed.
• If carriage does not move,
repeat Steps 1 through 8.
10. Remount remote (back on wall if approved
by customer).
11. Turn circuit breaker OFF.
12. Remount and secure control enclosure
covers.
13. Turn circuit breaker ON, and check
operation of all functions.
37
©Bruno Independent Living Aids, Inc.
ELECTRICAL
®
Publicidad
