Kärcher SC 1402 Manual De Instrucciones página 24

Power nozzle (D4)
The power nozzle is attached directly or
using the extension piece (D2) on the detail
nozzle. The power nozzle increases the
emission speed of the steam.
Application:
– removal of especially stubborn dirt
– cleaning out corners, joints, etc.
Manual nozzle (E1)
Pull the terry cloth cover (E2) over the manu-
al nozzle.
Application:
– small, washable surfaces, such as kit-
chen surfaces made of plastic, tiled walls
– windows, mirrors
– furniture fabrics
– vehicle interior, windscreens
– bath-tubs
Window nozzle (F1)
Application:
– windows
– mirrors
– glass surfaces on shower cubicles
– other glass surfaces
Apply steam to the glass surface from a
distance of approximately 20 cm until the
surface is moistened evenly. Then push
the lock (C3) to the rear to prevent an un-
desired actuation of the steam switch
(C4). Wipe the glass surface in straight li-
nes from the top to the bottom using the
rubber lip of the window nozzle. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Before cleaning with the window nozzle,
disolve fat residue using the manual
nozzle (E1) and a terry cloth cover (E2) .
24
English
Floor nozzle (H1)
Application:
– all washable wall and floor coverings,
e.g.: stone floors, tiles, and PVC floors.
Attach the floorcloth (H3) to the floor
nozzle (H1). Fold up the floorcloth
lengthways, and place the floor nozzle
on the cloth. Pull the jutting out ends of
the floorcloth one after the other under
the retaining clips (H2) (see Figure 10).
To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Turn and exchange the floorcloth in re-
gular intervals. Thus, you improve the
ability to pick up dirt.
Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a lon-
ger period of time.
If there are residues of detergents or
floor cleaning products (e.g. wax, liquid
polish) on the surface to be cleaned, st-
reaks may form during the cleaning. The-
se streaks normally disappear after a
repeated use of the steam cleaner.
Steam iron (K1) (optional)
Special accessory, see page 26 for the order
number.
Firmly insert the steam plug (K5) into the
appliance connector (A1). The locks of
the steam plug must lock into the cover
of the appliance connector.
Steam ironing
We recommend the use of the Kärcher iron-
ing table with active steam extraction. This
ironing table has been especially designed
to match your new unit. It facilitates and,
thus, accelerates the ironing process sub-
Figure 10