Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 18

To avoid possible injury, disconnect battery pack before performing any assembly, adjust-
ments or repairs.
Attaching Loose Parts
Attaching the Miter Lock Knob – Locate the miter lock
knob 12 from among the loose parts.
1. Look under the turntable's front arm above the lock
lever and locate the 10mm hole (see Fig. 1).
2. Insert the long shaft of the miter lock knob through
this hole until it stops.
3. Turn the knob clockwise (about 10 full revolutions)
until it is tight or "locked."
4. Loosen the knob 1/2 turn to unlock it. The table is
now free to be moved on the base.
Using the Miter Lock Knob –
1. Loosen the miter lock knob.
2. While holding the knob in your palm, reach down
with your index or middle finger and pull up the
detent lever. While gripping knob, rotate table left or
right to needed miter angle and release the lever.
3. Tighten the knob once you are at the correct angle.
NOTE: It is recommended to tighten the miter lock knob
before all cuts. It is required to tighten the knob before
cutting at any angle between detent engagements or
when the miter detent override system is in use.
Storing the 6/4mm Hex Key – There is a storage loca-
tion on the saw to store the 6/4mm hex key. Insert the
short leg of the hex key through the rubber grommet as
shown. Place the long leg into the tool rest and press
down into the retainer clip (see Fig. 2).
NOTE: The 6/4mm hex key is needed to change the
blade and to make tool adjustments. If lost, two sepa-
rate hex keys may be substituted: a 4mm hex key and
a 6mm hex key.
Inserting and Releasing Battery Pack
Slide charged battery pack 47 into the battery bay 46 until
the battery pack locks into position (Fig. 3).
Your tool is equipped with a secondary locking latch to
prevent the battery pack from completely falling out of
the battery bay, should it become loose due to vibration.
To remove the battery pack, press the battery pack
release button 48 and slide the battery pack completely
out of the battery bay (Fig. 3).
18
Assembly
Tool Rest
Retainer
Clip
Fig. 1
12
Fig. 2
6/4mm
Hex Key
Grommet
48
47
46