Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 33

To avoid possible injury, disconnect battery pack before performing any assembly, adjust-
ments or repairs.
Switch Activation
For safety, the switch lever 2 is designed to prevent
accidental starts. To operate safety switch, slide the
switch "Lock-OFF" release button 1 with either thumb
to disengage the lock, then pull the power switch trig-
ger and release the switch "Lock-OFF" release button
(Fig. 28). When the power switch trigger is released,
the switch "Lock-OFF" release button will engage the
power switch trigger automatically, and the lever will no
longer operate until either "Lock-Off" release button is
engaged again.
NOTE: Padlock hole 2a can accommodate a padlock
with a long shackle of up to 5/16" (8mm) in diameter
(not provided with miter saw) to prevent unauthorized
use.
Built-in LED Light
Your tool is equipped with a powerful LED light for bet-
ter visibility when cutting. The light has the ability to
turn on when only partially depressing the trigger (Fig.
28). The light will stay on for 30 seconds after the trig-
ger has been released. This allows the cut to be more
visible before the saw blade begins to spin.
Laser Line Guide
optics. Class 1M Laser product.
Your tool is equipped with a laser line guide that will turn
on when the trigger is partially depressed.
LASER LINE ADJUSTMENT
- Make sure the table is set to 0° miter position and
locked. Slide the head assembly all the way to the
back. Draw a straight cutting line on the workpiece.
Slowly lower the head assembly using the main han-
dle.
- Position the workpiece so that the teeth of the saw
blade line up with the cutting line. Hold the work-
piece in this position and slowly guide head assem-
bly back up. Clamp the workpiece.
- Turn on the laser beam by depressing the trigger
without pressing the lock-off button (Fig. 28). The
laser beam must be aligned with the cutting line on
the workpiece along its entire length (Fig. 29).
If adjustment is required, turn the left 51a and right
51b set screws with a 2.5mm hex allen wrench until
the laser beams are aligned with the cutting line on the
workpiece.
Preparing for Saw Operations
Laser radiation. Do not
expose users of telescopic
Fig. 28
3
1
2
2a
Fig. 29
51a
Laser Line
(Left)
One full turn of the set screw counterclockwise moves
the laser beam from left to right; one full turn of the set
screw clockwise moves the laser beam from right to left.
31
50
51b
Cutting Laser Line
Line (Right)
33