Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 22

To avoid possible injury, disconnect battery pack before performing any assembly, adjust-
ments or repairs.
Using the Head Assembly
Lock Pin
HEAD ASSEMBLY LOCK PIN
The head assembly lock pin 43 is located on the right
side of the pivot post 34. It is used to hold the saw's
head assembly in the DOWN position. This position
prevents the head from bouncing up and down during
transportation. This also makes the saw more compact
for lifting and storage. This position is also required for
some calibrating procedures.
TO ENGAGE THE HEAD ASSEMBLY LOCK PIN
1. Check that the depth stop plate 33 is disengaged, or
pressed in to the right position.
2. Grasp the saw's main handle 3 and press down on
the head assembly.
3. While pressing the saw head down, push in on the
head assembly lock pin. Release the head assem-
bly. The head will be locked in the DOWN position
(see Fig. 8).
TO DISENGAGE THE HEAD ASSEMBLY LOCK
PIN
1. Grasp the main handle and press down on the head
assembly.
2. While pressing the head down, pull out the head
assembly lock pin. Release the lock pin, but main-
tain your grip on the main handle. Slowly allow the
spring-loaded saw head to come up to the top of its
travel and then release the handle.
Using the Glide Movement Controller
TO ADJUST THE GLIDE MOVEMENT
CONTROLLER
The glide movement controller 44 is attached to the
upper joint of the glide mechanism; it is designed to
control the smoothness of the saw's glide action. When
assembled at the factory, the controller is not adjusted;
therefore, the movement is very smooth. To adjust the
glide mechanism's smoothness, slightly tighten or loos-
en the two screws at the top by using the 6/4mm hex
key or a 4mm hex key (see Fig. 9).
22
Adjustments
Fig. 8
33
43
34
3
Fig. 9
Screws
(x2)
6/4mm
Hex Key
44