Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 41

Using Miter Detent System
1. Loosen the miter lock knob 12 about 1/2 turn.
2. Grip the lock knob, and then reach down with your
index finger to pull up on the miter detent lever 13 –
pull lever until it is out from the detent plate.
3. While gripping the lock knob and lever, rotate the
saw's table. Stop table rotation at the desired angle
as indicated by the miter scale pointer 15.
4. Release the lever into a detent 17 in the detent
plate 16 or at an angle between detents. If close to a
detent, use the detent override feature.
5. Tighten the miter lock knob before cutting.
NOTE: It is recommended to tighten the miter lock knob
before all cuts. It is required to tighten the knob before
cutting at any angle between detents or when the miter
detent override system is in use.
Miter Detent Override
The miter detent override feature allows the miter
detent action to be locked out, allowing for micro
adjustments at any miter angle. When the desired miter
angle is too close to a standard mitering angle that has
a detent slot, this feature prevents the wedge on the
miter detent lever from slipping into the detent slot on
the miter detent plate.
1. Lift and hold the miter detent lever 13.
2. Push the detent override clip 11 forward and latch in
place over receiving edge on turntable arm. Release
miter detent lever (Fig. 41).
3. Rotate table to any position on the miter scale.
4. Lock the miter lock knob to retain miter position.
To Disengage:
Loosen miter lock knob and lift the miter detent lever
to release the detent override clip. The clip should auto-
matically disengage and the table should lock into any
desired miter detent.
Saw Operations
16
Fig. 41
17 15 13 12
17
13 12
Fig. 40
11
41