Husqvarna K 535i Manual De Usuario página 11

• Do not charge non-rechargeable batteries in the
battery charger or use them in the machine.
• Use approved mains sockets that are not damaged.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
Applicable cutting blades
Cutting blades for Husqvarna K 535i are available in two
basic models: abrasive blades and diamond blades.
Cutting blades for handheld high speed
power cutters
WARNING:
and abrasive blades for concrete. Do not
use blades with serrations such as circular
wood cutting blades or blades with carbide
tips. The risk of kickback is increased and
carbide tips can come off and be thrown at
high speed. This can result in injury or
death.
WARNING:
the blade to become too hot. A blade that is
too hot can cause malfunction, which can
cause damage and injury.
10
Read the warning
Assembly
Only use diamond blades
Incorrect use can cause
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
WARNING:
with a lower maximum speed than that of
the power cutter. Only use cutting blades
that are in compliance with national or
regional standards.
Note:
Only cut materials approved in the instruction
supplied with the blade.
Check that the blade is approved for the same or higher
speed written on the type plate of the power cutter.
Blade vibration
CAUTION:
too much force, the blade can get too hot,
bend and cause vibrations. Use the product
with less force. If the vibrations continues,
replace the blade.
Do not use a cutting blade
100 m/s
XXXX rpm
If you use the product with
745 - 008 - 12.11.2018