Husqvarna K 535i Manual De Usuario página 13

Wet cutting
CAUTION:
together with the wet system.
• Diamond blades for wet cutting must be used with
the wet system.
• Water cool the blade and increases its service life
while also decrease the dust.
• When wet cutting, make sure to collect the waste
water safely.
Dry cutting
• When dry cutting, lift the blade out from the cut each
30–60 seconds and let it rotate in the air for 10
seconds to let it cool.
• Use Vac equipment if possible.
Diamond blade - requirements
WARNING:
segment (T1) is wider than the blade (T2).
This is to prevent pinching in the cutting slot
and a kickback.
12
Do not use Vac equipment
Make sure the diamond
T1
T2
CAUTION:
with positive rake angles.
CAUTION:
with greater gap between segments than
max 10 mm (A).
A
CAUTION:
with greater blade thickness than
recommended maximum, refer to
data on page 23 .
Do not use diamond blades
Do not use diamond blades
Do not use diamond blades
Technical
745 - 008 - 12.11.2018