4. Press and hold the start/stop button until the green
LED light comes on.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the blade speed and gives the
longest operation time from the battery.
Note:
The SavE function does not decrease the
cutting power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out.
To stop the product
1. Press and hold the start/stop button on the keypad
until the green LED light goes out.
16
2. Press the battery release buttons and remove the
battery from the battery holder.
WARNING:
you do not use or when you do not have full
vision of the product. This is to prevent
accidental start.
Basic working techniques
WARNING:
cutter to the side. This can prevent the free
movement of the blade and cause the blade
to break, which can cause an injury.
WARNING:
blade. The blade can become damaged and
broken, which can cause an injury. Use only
the cutting edge.
WARNING:
blade to cut plastic material. The heat that
occurs can melt the plastic. Melted plastic
can attach to the cutting blade and cause a
kickback.
•
The product is made for high speed diamond blades
approved for handheld power cutters.
•
The product is made to cut in to tiles, light concrete
and stone. Use only for this type of operation.
•
Make sure that the cutting blade does not show
signs of damage and that it is attached correctly, see
Abrasive blades on page 11 and To attach the
cutting blade on page 13 .
•
Make sure to use the correct cutting blade for the
type of operation, see
high speed power cutters on page 10 .
•
Do not cut asbestos material.
•
Always hold the power cutter with 2 hands. Always
hold the product tightly with thumbs and fingers
around the handles. Always hold the rear handle
with the right hand and the front handle with the left
hand.
Remove the battery when
Do not move the power
Do not use the side of the
Do not use a diamond
Cutting blades for handheld
745 - 008 - 12.11.2018