Publicidad
86
Technical Manual & Parts Book
ASSEMBLY / ADJUSTMENT INSTRUCTIONS
1345-3C
1. Position the column assy (item A) with the lower edge
below the bottom of the slide support bracket (item B).
DO NOT ADJUST WITHT THE COLUMN OR TABLE IN THE
"UP" POSITION.
2. Loosen the (8) screws (item C) holding the slide support
bracket (item B) and the jam nuts (item D) for the top and
bottom adjustment screws (item E).
3. Tighten or loosen the (4) upper and (4) lower adjustment
screws (item E) as required to put pressure on the column
assembly (item A) and align it in the support column.
NOTE: EXCESSIVE PRESSURE WILL CAUSE BINDING AND
PREMATURE FAILURE OR WEARING OF PARTS. Apply only
the minimun ammount of pressure required to reduce the
rotational movement of the table to an acceptable level.
4. Tighten the (8) top and (8) bottom support screws (item C).
5. Bolt the table top to the column and add shims if
necessary to level the table parallel to the frame.
Publicidad
