Publicidad
Idiomas disponibles
Idiomas disponibles
5
Troubleshooting and repairs
This product has been developed and assembled using the best individu-
al components available. It is designed to give longevity and high perfor-
mance. If spare parts are used during the life of this product, please ensure
that they are genuine Heiniger parts. Failure to use genuine Heiniger spares
may reduce the performance of this precision engineered product and will
void any warranty claim.
5.1
Introduction
WARNING!
The following troubleshooting guide will aid in determining prob-
lems and offer a solution.
For information on authorised service points, see chapter "7 Con-
tact address".
An authorised service agent is to be contacted in the event of
malfunctions that are not contained in this manual.
5.2
Troubleshooting
5.2.1 Sheep clipper head
Malfunction
Upper blades move too
little
Top blade does not move
Pressure regulator screw
jammed
Leaf springs in the head
mount are too loose.
Pivot lever has play to the
pivot spring lever
Pivot lever difficult to move
up and down.
16
Cause
Eccentric square lost
(Fig. 1a, item 7)
Leaf springs completely
broken
Eccentric square and/or
eccentric shaft are worn
out (insufficient lubrication)
(Fig. 1a, item 7)
Faulty gear (Fig. 1a, item 12) Replace gear
Faulty reduction gear
Thread dirty or rusty
(Fig. 1a, item 3)
Pressure spring jammed.
Loosen fixing screws
Leaf springs and/or cap
screws are worn out
Centring sleeve lost.
Translation of the original instructions / Clipper
Rectification
Replace eccentric square
Notify customer service
Replace eccentric square
Notify customer service
Notify customer service
Clean and oil the thread
Notify customer service
Tighten fixing screws
Notify customer service
Notify customer service
Publicidad
