Changing The Clipper Head (Fig. 13, Option); Storing The Clipper (Fig 14) - Heiniger USV/L Traducción Del Manual Original

4.5

Changing the clipper head (Fig. 13, option)

To change the clipper head from "sheep" to "livestock" or vice versa, loosen
the two screws on the clipper head. Remove one clipper head and mount
the other one (grease the gear Fig. 1a, item 12 if necessary). Retighten the
two screws.
4.6

Storing the clipper (Fig 14)

CAUTION!
Only store the clipper in dry rooms and in the case supplied. If liq-
uid is suspected to have entered the machine, do not switch it on
again. There is a danger of electric shock or short circuit. Hand
over the clipper to a service centre.
Get into the habit of always giving the clipper a good clean after use, oiled
and with the clipping system relaxed in the equipment case, store the de-
vice in a dry and clean location out of the reach of children.
Translation of the original instructions / Clipper
15