cecotec BOLERO COOLMARKET 4D 564 INOX E Manual De Instrucciones página 67

- The appliance should be kept away from damp or wet environments. Water or dirt should
be removed from any surface of the appliance as soon as possible with a soft cloth. This
will help prevent rust and help your appliance run at maximum efficiency.
- Place the refrigerator in a well-ventilated place, reserve some space around and behind
the refrigerator, and do not cover or block the air grille of the compressor rear cover plate
at the back of the refrigerator. Keep the refrigerator away from heat sources or direct
sunlight.
Adjustable feet (Fig. 7)
- In the refrigerator packing box, feet come tightly packed. After removing the refrigerator
from the box for installation, be sure to adjust the two front feet to the desired height;
adjust the two feet with a spanner or directly by hand.
- The feet and rear rollers must touch the floor to prevent the refrigerator from moving,
vibrating, or rattling.
- When moving the refrigerator, adjust the feet counterclockwise so that they do not touch
the floor, then gently tilt the refrigerator to start moving it.
Door shelf
- Disassembly: hold both sides of the door shelf with both hands. Hold the sides of the door
shelf with both hands. Push it in from the side opposite the slot and push it in as shown
in Figure 8. Push until the edge of the door shelf separates from the groove in the slide.
- Assembly: hold the sides of the door shelf with both hands. Install the clip on the slot first.
Then, push the other side slightly inwards–the clip will click into place on the slot and the
door shelf will be installed. Make sure the appliance is installed correctly before using it.
(Fig. 8)
Fig. 8 key:
1. Door-shelf slide
2. Door lining
3. Door shelf
Instructions for locking the water dispenser (Fig. 9)
- Push the child safety lock lever with your thumb as shown in Figure 9 (arrow 1)–the lever
(2, Fig. 9) will lock and it will, in turn, lock the water dispenser.
- Push it in the opposite direction to unlock the water dispenser.
Instructions for installing the water tank (Fig. 10)
- Grasp both sides of the tank with your hands and pull the tank assembly slightly upwards
out of the door.
- Turn the water valve assembly counterclockwise to remove it from the water tank for
cleaning.
- Move the tab on the water-tank cover slightly upwards to detach the water-tank cover
BOLERO CO OLMARKE T 4D 5 64 I NOX / DA RK /G L A SS E
ENGLISH
67