Sony M-crew MDS-PC3 Manual De Instrucciones página 29

Problem
The installed devices are not set
properly.
No sound comes out of the built-
in or external speakers of the
computer.
No sound from the system stereo
component comes out of the
built-in or external speakers of
the computer.
The message "Could not connect
to the CDDB." appears.
The system sounds (warning
alarm/mail arrival notice) are not
heard.
Cause/countermeasure
t Refer to the "Readme.txt" file in the Start
menu. The "Readme.txt" file is in the folder
which the M-crew software is installed in.
The USB audio device is preferred on the
computer that has a USB connection to a system
stereo component.
t Select the standard audio device (usually the
built-in sound card of the computer) for the
preferred device in the "Sounds and
Multimedia Properties" dialog box (page 17).
t Connect the analog output terminal on the
system stereo component and the line-in
terminal on the computer with an audio cable,
and then uncheck the "Mute" check box under
the "Line In Balance:" section in Volume
Control.
t Check that you are successfully connected to
the Internet.
t If you have access to the Internet through a
proxy server, check the proxy settings in the
"Option" dialog box.
t The system sounds have been specified not to
sound during M-crew startup, or the setting
may have changed to OFF when M-crew was
abnormally ended. To restore the sounds,
restart M-crew and then quit the program
normally. Or double-click the backup file
(reg0.reg to reg3.reg) in the M-crew folder
and follow the instructions to set up the
program again (except for Windows XP).
29 GB