Step 2: Connecting The System; Connecting The Speakers - Sony BDV-F700 Manual De Instrucciones

Step 2: Connecting the System

For connecting the system, read the information on the following pages.
Do not connect the AC power cord (mains lead) of the unit to a wall outlet (mains) until all the other
connections are made.
Note
• When you connect another component with a volume control, turn down the volume of the other components to a
level where sound is not distorted.
To remove the panel cover of the unit
Before connecting the cables, remove the panel cover from the unit.
Hold the panel cover at (A), then slide it out to
the side.
Note
• Before using the unit, remove the seal attached at the lower rear of the unit.

Connecting the speakers

The connector of the speaker cords and the color tube are color-coded depending on the type of speaker.
Connect the speaker cords to match the color of the SPEAKERS jacks of the unit.
Be sure to match the speaker cords to the appropriate terminals on the speakers: the speaker cord with
the color tube to 3, and the speaker cord without the color tube to #. Do not catch the speaker cord
insulation (rubber covering) in the speaker terminals.
20
GB
A