Electrolux EN6084JOX Manual De Instrucciones página 19

The motor runs con-
tinuously
A layer of frost occurs
in the compartment
Temperature inside is
too warm
Temperature inside is
too cold
Doors can't be closed
easily
Water drips on the floor
The light is not working
Doors does not open
smoothly
11. DISPOSAL OF THE APPLIANCE
The refrigerator is built from reusable
materials. It must be disposed of incom-
pliance with current local waste disposal
regulations. The appliance contains a
small quantity of refrigerant (R600a) in
the refrigerant circuit. For your safety
please refer to the section of "the refrig-
erant and risk of fire" in this Instruction
Manual before scrapping the appliance.
It is normal to frequently hear the sound of the motor, it
will need to run more when in following circumstances:
• Temperature setting is set colder than necessary
• Large quantity of warm food has recently been stored
within the appliance.
• The temperature outside the appliance is too high.
• Doors are kept open for a long period.
• After your installing the appliance or it has been
switched off for a long time.
Check that the air outlets are not blocked by food and en-
sure food is placed within the appliance to allow sufficient
ventilation. Ensure that door is fully closed. To remove the
frost, please refer to "cleaning and care" section.
You may have left the doors open too long or too fre-
quently or the doors are kept open by some obstacle; or
the appliance is located with insufficient clearance at the
sides, back and top.
Increase the temperature by following the "Display con-
trols" chapter.
Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self close or if something
inside is preventing the doors from closing.
The water pan (located at the rear bottom of the cabinet)
may not be properly leveled, or the draining spout (located
underneath the top of the compressor depot) may not be
properly positioned to direct water into this pan, or the
water spout is blocked. You may need to pull the refrigera-
tor away from the wall to check the pan and spout.
The LED light may be damaged. Refer to replace LED
lights in cleaning and care chapter.
The control system has disabled the lights due to the door
being kept open too long, close and reopens the door to
reactivate the lights.
Check the door seal, and if it is necessary clean the rub-
ber gasket seal around the edges of the door using dish
soap and warm water. Dirt and grime can collect here and
cause door stick to the fridge.
Please cut off the power cord to make
the refrigerator unusable and remove the
door seal and lock. Please be cautious of
the cooling system and do not damage
it by puncturing the refrigerant con-
tainer and/or bending the tubing, and/or
scratching of the surface coating.
ENGLISH
19