Publicidad
Idiomas disponibles
Idiomas disponibles
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Tighten the fuel tank cap carefully.
4. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before starting.
Note: To see where the fuel tank is on you product, refer
to
Product overview on page 3 .
To do a run-in
•
During the first 10 hours of operation, do not apply
full throttle without load for extended periods.
To use the correct chain oil
WARNING: Do not use waste oil, which can
cause injury to you and the environment.
Waste oil also causes damage to the oil
pump, the guide bar and the saw chain.
12
WARNING: The saw chain can break if the
lubrication of the cutting equipment is not
sufficient. Risk of serious injury or death to
the operator.
WARNING: This product has a function that
lets the fuel run out before the chain oil. Use
the correct chain oil for this function to
operate correctly. Speak to your servicing
dealer when you select your chain oil.
Note: This product has an automatic chain lubrication
system. You can also adjust the oil flow. Refer to
adjust the oil flow on page 33 .
•
Use RedMax chain oil for maximum saw chain life
and to prevent negative effects on the environment.
If RedMax chain oil is not available, we recommend
you to use a standard chain oil.
•
Use a chain oil with good adherence to the saw
chain.
•
Use a chain oil with correct viscosity range that
agrees with the air temperature.
CAUTION: If the oil is too thin, it runs out
before the fuel. In temperatures below
0°C/32°F some chain oils become too
thick, which can cause damage to the oil
pump components.
•
Use the recommended cutting equipment. Refer to
Accessories on page 36 .
•
Remove the cap to the chain oil tank.
•
Fill the chain oil tank with chain oil.
•
Attach the cap carefully.
Note: To see where the chain oil tank is on you product,
Product overview on page 3 .
refer to
Kickback information
WARNING: A kickback can cause serious
injury or death to the operator or others. To
decrease the risk you must know the causes
of kickback and how to prevent them.
A kickback occurs when the kickback zone of the guide
bar touches an object. A kickback can occur suddenly
To
993 - 003 - 30.01.2019
Publicidad
