Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
10.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SPOOL
1. Push the tabs on the sides of the trimmer head at the same
time.
Tab
2. Pull and remove the spool cover.
3. Remove the remaining spool.
4. Put the spool in the spool housing.
Cover
Spool
English
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
10.4
REPLACE THE CUTTING LINE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65 mm)
diameter.
1. Cut two pieces of cutting line approximately 3m long of
each.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Put the lines into the anchor holes of the spool.
4. Wind the cutting lines around the spool tightly in the
indicated direction.
10
NOTE
NOTE
NOTE
Publicidad
