Migatronic FLEX2 3000c Compact Manual De Instrucciones página 19

Switch on Press  Weld
The machine is almost ready to use

Switch on the welding machine
on the main switch (2)

Select internal/external control (see page 20)

Select welding program
A welding program must be selected in relation to welding wire,
shielding gas or possible electrode.
Please read how this should be selected on your welding
machine in the quick guide.

Adjust the welding current
Please read your quickguide

Weld
SOFTWARE
In case of exchange of the control unit, software must be reloaded,
using an SD card.
Latest software can be downloaded at www.migatronic.com.
Save the software on an SD card containing the folders and one or
more of the files shown below.
To order SD card, use item no. 26460002.
Software reading

2
Insert the FLEX 3000 Compact SD-card in the slide in the
right side of the machine.

Turn on the machine.

The display flashes shortly with six lines.

Wait until the set current is displayed.

Turn off the machine and remove the SD card

The machine is now ready for use.

All machine user settings are deleted when the file
10645900.bin has been inserted. Therefore, always remove
the SD-card from the machine after the software update.
Thereby, continuous software update is avoid each time
the machine is turned on.
If the SD-card contains software for other units e.g.:
10020115.cry RWF
10020113.cry RCI
These units will be updated if they are connected to the CAN
network.
Please note that this update will be longer in time, so please do not
turn off the machine until the standard control panel will be displayed
2
at FLEX 3000 Compact.
Licence SW
If additional licences for programs or special functions have been
bought, then the MigaLic.dat files should be read by the machine in
the same way as SW-packages. Please remember to save a backup
file.
The MigaLic.txt file contains information about machine licence
number and containing licences at the SD-card.
19