Publicidad
Idiomas disponibles
Idiomas disponibles
Configuration of internal/external control
It is possible to configure internal and external control by pressing the
following key pad in the Machine Setup-menu:
Turn the lower control knob until the requested configuration is
displayed. Press the
-knob to confirm the selection (selected
configuration is indicated by
):
Dialog torch:
Current can be adjusted both on the control panel and on the control
wheel on the welding torch. Voltage trim can be adjusted from the
control panel.
Sequence torch:
3 or 7 sequences are automatically defined when selecting between
3 or 7 sequence torch. Change of sequences can only be carried out
from the torch. All other settings are carried out internally on the
control panel.
IMPORTANT!
It is not possible to shift between sequence number 1 to 7 (1 to 3 at
the ERGO model XMA) if the wrong sequence torch has been
selected. Please select a suitable type from the list.
Remote control:
Current can be adjusted both on the control panel and from the
control knob on the remote control.
Voltage trim can only be adjusted from the remote control.
®
MIG Manager
:
Read quick guide for MIG Manager
SPECIAL FUNCTIONS
®
Connection/disconnection of water cooling (MIG/MAG)
The water cooling function will ensure protection of the water-cooled
torch. The water cooling will automatically be activated when
welding is started and stops automatically 3 minutes after welding
has been completed. Water cooling is activated by pressing the
following key pad:
®
When a MIG Manager
is connected, it will automatically control the
water cooling function and disable this configuration.
Setting of time
It is possible to set the time by pressing the following key pad in the
Machine Setup-menu:
It is important to set the correct time, if logging of e.g. errors should
be used. The setting is confirmed by pressing the following key pad
after the setting is completed:
20
Publicidad
