Migatronic FLEX2 3000c Compact Manual De Instrucciones página 17

PRODUCT PROGRAMME
2
FLEX 3000 Compact:
300A welding machine for MMA and MIG/MAG welding. The
machine is air-cooled and is supplied with integrated trolley and
built-in wire feed unit with 4-roll drive.
Welding hoses and cables
MIGATRONIC's product range can provide electrode holders,
MIG/MAG torches and hoses, return current cables, intermediary
cables and wear parts etc.
Push pull (option)
2
FLEX 3000 Compact can be retrofitted with extra equipment;
thereby a MIGATRONIC Push Pull torch can be connected and
used.
Torch cooling (option)
When ordering the machine, an integrated cooling module can be
ordered, which enables both water-cooled and gas-cooled
welding torches to be used.
Trolley with unit for changable voltage (option)
A trolley with a built-in unit which automatically adjusts the actual
three-phased mains voltage (230-500V) to the FLEX
Compact.
Intelligent Gas Control (option)
Gas saving kit, which automatically adjusts the gas flow.
Accessories
Please contact your Migatronic dealer for further information on
2
FLEX 3000 Compact accessories.
CONNECTION AND OPERATION
Permissible installation
The following sections describe how the machine is made ready for use
and then connected to mains supply, gas supply etc. The numbers in
parentheses refer to the illustrations in this paragraph.
Dispose of the product according to local standards and
regulations. More information can be found under Policies at
www.migatronic.com
Configuration
MIGATRONIC disclaims all responsibility for damaged cables and other
damages related to welding with undersized welding torch and welding
cables measured by welding specifications e.g. in relation to
permissible load.
Important!
In order to avoid destruction of plugs and
cables, good electric contact is required when
connecting earth cables and intermediary
cables to the machine.
2
3000
Generator use
This welding machine can be used at all mains supplies providing
sine-shaped current and voltage and not exceeding the approved
voltage tolerances stated in the technical data. Motorised generators
observing the above can be used as mains supply. Consult your
supplier of generator prior to connecting your welding machine.
MIGATRONIC recommends use of a generator with electronic
regulator and supply of minimum 1.5 x the maximum kVA
consumption of the welding machine. The guarantee does not cover
damage caused by incorrect or poor mains supply.
Mains connection
Before connecting the power source to the mains supply, ensure that
the power source is of the same voltage as the mains voltage provided
and that the fuse in the mains supply is of the correct size. The mains
cable (1) of the power source must be connected to the correct three-
phase alternating current (AC) supply of 50 Hz or 60 Hz and with earth
connection. The sequence of the phases is not of significance. The
power source is switched on with the mains switch (2).
Important: stretch out welding hose, earth cable and interconnecting
cable, as necessary, as shown in the figure to avoid affecting the
welding performance and at worst destructing the welding machine.
17