Setting The Paint Jet Pattern; Adjusting The Paint Flow; Adjusting The Airflow; Maintenance And Cleaning - Parkside PDWS 125 A1 Instrucciones De Uso

Setting the paint jet pattern

The appliance has two settings: round jet and
broad jet.
Round jet
Setting the round jet:
■ Use the round jet for small surfaces, corners
and edges.
♦ Turn the control
Setting the broad jet:
■ You can use the broad jet vertically or horizon-
tally for larger surfaces.
♦ Turn the control
The nozzle head
position between the horizontal and the vertical.
Adjusting the paint flow
NOTICE
► The front locking bolt is designed to limit the
adjustment range of the stroke limiter screw
Increasing the paint flow:
♦ Turn the stroke limiter screw
Decreasing the paint flow:
♦ Turn the stroke limiter screw
│
■ 6 US - EN
Broad jet
clockwise .
clockwise .
can be turned into any
anticlockwise.
clockwise.
Adjusting the airflow
NOTICE
► We recommend starting with the airflow set
to maximum. To do this, open the airflow
regulator
in the section "Increasing the airflow".
Increasing the airflow:
NOTICE
► Increasing the airflow is generally advisable
if the dispersion is too coarse.
♦ Turn the airflow control
Decreasing the airflow:
NOTICE
► Decreasing the airflow is generally advisable
if the paint mist is too strong.
♦ Turn the airflow control

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
. NOTICE
► Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot
be guaranteed.
■ Wear suitable gloves when cleaning.
■ Do not use any hydrocarbon-based solvents
like benzene, ethyl chloride, etc., as these could
trigger chemical reactions with some of the
materials in the paint spray gun. This can lead
to dangerous reactions.
to maximum as described below
anticlockwise.
clockwise.
PDFP 500 C3