Garland MONTANA 110J-V16 Manual De Instrucciones página 45

Example (B) corresponds to a chain that is too loose.
6. Tighten the nut (1) (12-15 Nm) .
Check that the chain slides along the rod, keeping
proper tension at all times whenever you move
your hand. If it is necessary, repeat the tensioning
procedure until the chain is correctly installed.
New chains have a certain expansion when first
used. Check and adjust the chain tension regularly.
6.3. CHECK POINTS BEFORE COMMISSIONING
Remove the protector (1).
1
Check the machine and look for loose parts (screws,
nuts, shells, etc.) and damage. Tighten, repair, or
replace the parts you found in poor condition.
Make sure that there are no leaks or loss of fuel.
Do not use the machine if it is damaged or improperly
adjusted.
6.3.1. CHECK OF THE SAFETY BRAKE
If it bounces, the tip of the chain rod rises sharply, the
chainsaw changes angle quickly so that the user does
not give time to change the position of the arm that
collides against the security guard and activates the
emergency brake.
The emergency brake can be activated at any time by
pushing forward security guard.
To remove the emergency brake,
pull the guard backward until you
hear a "click".
Be sure to check the emergency brake every time you
use the chainsaw.
CHECK OF THE SAFETY BRAKE
1. Turn off the engine.
2. Activate the emergency
brake by pushing the
safety guard until you hear
a "click".
3. Hold the chainsaw horizontally at about 40 cm
from the piece of wood, remove your hand from
the front handle and leave the chainsaw turn
with the right hand until the end of the rod comes
in contact with the wood.
If the brake works properly, the chain should not
move in the moment in which it comes in contact with
the wood. In the event that the brake is not acting
properly, you must take chainsaw in for a service
revision.
Do not start the chainsaw if the emergency brake is
activated. If the chain is blocked by the brake, the
clutch will heat up and may be damaged.
6.3.2. BLEND OF GASOLINE AND OIL
Use unleaded gasoline 95 octane and
100% synthetic two stroke oil.
Engine fuel: mix synthetic oil and
gasoline (Gasolina40: oil 1 = 2.5%). Mix gasoline
and oil in a CE-approved container.
Do not use fuel that it has been stored for more than
2 months. A fuel that has been stored for too long will
make the starting of the machine more difficult and
result in unsatisfactory engine performance. If the fuel
has been in the tank of the machine for more than two
months, empty the machine of the old fuel and replace
it with one in perfect condition.
45/160
English