Circuit Breakers / Fuse; Hour Meter; Draining Tanks - Tennant 5400 Manual Del Operador

OPERATION
7. Squeeze lever on wand and spray solution on
floor. Scrub floor with brush side of wand and
vacuum up solution with squeegee side of wand
(Figure 32).
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
FIG. 32

CIRCUIT BREAKERS / FUSE

The 5400 is equipped with five resettable circuit
breakers and one fuse to protect machine from
damage. If a circuit breaker should trip during
operation, determine cause, allow motor to cool and
then manually reset breaker. If replacing the fuse,
never substitute a higher fuse than specified. Circuit
breaker panel is located at rear of machine
(Figure 33).
– 10A Main Circuit Breaker
– 15A Drive Motor Circuit Breaker
– 25A Vacuum Motor Circuit Breaker
– 30A Brush Motor Circuit Breaker (2)
– 2A Circuit Board Fuse
–10A FaSTt System (option)
FIG. 33
16
Home Find... Go To..

HOUR METER

The hour meter records number of hours the machine
has been powered on. Use hour meter to determine
when to perform recommended maintenance
procedures and to record service history (Figure 34).
FIG. 34

DRAINING TANKS

Drain recovery tank:
– After each use.
– Between solution tank refills.
– When squeegee starts trailing water.
– When solution flow stops.
– When float shut-off screen, located inside
recovery tank, is activated.
– If optional ESt indicator light remains on.
1. Drive machine to floor drain and turn key off.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
2. Remove drain hose from hose hook. Right side
hose drains recovery tank and left side hose
drains solution tank. Turn drain hose knob
counter-clockwise and pull plug out to drain
(Figure 35).
Recovery
Tank
Hose
Solution
Tank
Hose
FIG. 35
Tennant 5400 (05–03)