Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. Always keep the Tribest Sedona Express on a level surface.
• Keep the Tribest Sedona Express at least 10 cm away from walls, other appliances or furniture.
2. Open the door to insert trays into the Tribest Sedona Express. Hold the tray in the horizontal
position and push the tray into the proper slots.
• Place the food evenly and neatly on each tray as close as possible (remember dehydrating
removes water and/or shrinks food). For best results, cut the food into even sizes and thickness
so that dehydration will be completed altogether.
• It is recommended to use separate trays for each type of food.
• You may dehydrate up to 11 trays simultaneously.
• Double check whether all the trays are properly loaded.
For model SDE-P6280, there is a 250 gram capacity per each plastic tray.
3. Plug into an outlet that has 10-amp capacity.
4. Turn the main switch ON.
5. There are three settings to choose with the Sedona Express:
• COMBO Mode (with TST) Use Only
The Two-Stage Sequential Temperature-Timer (TST), a two-phase COMBO mode that allows for both
FAST mode and RAW mode to be applied sequentially. This is the default setting of the Sedona
Express when it is turned on.
1) Turn the Sedona Express on, both the RED and GREEN lights to the right of the MODE button
will be lit. (Red=FAST mode, Green=RAW mode.)
2) Press the °F/°C button to choose Fahrenheit or Celsius.
3) Press the SET button to set FAST mode to your desired temperature using the UP/DOWN 10
or 1 buttons.
4) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for FAST mode.
5) Press SET again to set the desired temperature using the UP/DOWN 10 or 1 buttons for RAW
mode.
6) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for RAW mode.
7) Press SET to finalize settings.
8) Press the START/PAUSE button to begin operation.
NOTE: During COMBO mode operation, the upper red light blinks while the Sedona Express first oper-
ates at the higher temperature for the set amount of time; and then, the lower green light blinks, when
the temperature automatically lowered to the second setting for the remaining dehydrating time.
• FAST Mode Use Only
This setting holds and maintains a higher temperature (e.g. 167°F) for faster dehydrating. The
temperature in the dehydration chamber may fluctuate above and below the set temperature as the
heating elements cycle on and off.
1) Set the Sedona Express to FAST mode by pressing the MODE button once to change the
default COMBO mode to FAST mode. (A RED light lit to the upper right of the MODE button
indicates that the Sedona Express is set at FAST mode.)
2) Press the °F/°C button to choose Fahrenheit or Celsius.
3) Press the SET button to set FAST mode to your desired temperature using the UP/DOWN
10 or 1 buttons.
4) Press the SET button once again to set your desired time using the UP/DOWN 10 or 1 buttons.
5) Press the SET button again to finalize your settings.
6) Press the START/PAUSE button to begin operation.
14
Publicidad
