Publicidad
Idiomas disponibles
Idiomas disponibles
• RAW Mode (with Overheat Protection) Use Only
This setting prevents the temperature of the dehydration chamber from going over the selected tem-
perature setting. The temperature in the dehydration chamber never fluctuates above the set tem-
perature as the heating elements cycle on and off, which prevents your food from being overheated.
1) Set the Sedona Combo to RAW mode by pressing the MODE button two times. (A GREEN light
to the lower right of the MODE button will indicate that the unit is set on RAW mode.)
2) Press the °F/°C button to choose Fahrenheit or Celsius.
3) Press the SET button to set RAW mode (the GREEN light is blinking) to your desired
temperature using the UP/DOWN 10 or 1 buttons.
4) Press the SET button to set RAW mode to your desired time using the UP/DOWN 10 or 1 buttons.
5) Press the SET button to finalize your settings.
6) Press the START/PAUSE button to begin operation.
6. Tribest Sedona Express will automatically switch to stand-by mode after the drying time has
expired. Also, a beep will sound when the drying time has expired.
7. Turn the main switch OFF after dehydration has finished.
• Tribest Sedona Express is designed to evenly distribute warm air from the rear to the front of
the unit. Depending on the climate and temperature of the air flowing into the unit from the
rear, there may be a slight difference in temperature between the trays and inside the drying
compartment.
• Because heat rises naturally, it is normal for the top trays to be exposed to more heat than the
trays in the center or on the bottom. For best results, rotate the trays periodically.
EN
15
Publicidad
