YASKAWA Varispeed F7 CIMR-F7C Serie Instrucciones Básicas página 6

Varispeed F7
3. Digital Operator
Status LEDs
FWD: Lights up when a forward
run command is input.
REV: Lights up when a reverse
run command is input.
Mode Display
DRIVE: Lights up in Drive
Mode.
QUICK: Lights up in Quick
Programming Mode.
ADV: Lights up inAdvanced
Programming Mode.
VERIFY: Lights up in Verify
Mode.
A.TUNE: Lights up in
Autotuning Mode
Key
Changes over from control
with the digital operator to
control via the terminal
block.
Invokes the JOG speed,
which has top priority.
Reverses the direction of
rotation of the motor.
Starts the motor. The LED in
the top left corner of the but-
ton comes on to indicate
that the motor is running.
Increases the parameter
number or data value.
6
REF: Lights up when the fre-
quency reference from con-
trol circuit terminals A1 and
A2 is enabled.
SEQ: Lights up when the run com-
mand from the control circuit
terminal is enabled.
BASIC INSTRUCTIONS
ALARM: Lights up when an error
or alarm has occurred.
Data Display
Displays monitor data, con-
stant numbers, and settings.
Key
Returns to previous menu in
the hierarchy without sav-
ing.
Switches menu within the
hierarchy.
Adopts parameter setting
data. Entering a parameter
number in the PRGM mode
displays the associated
data.
Advances position on the
display. Pressing this button
when there is a malfunction
resets the inverter (acknowl-
edgement)
Stops the motor. The LED in
the top left corner of the but-
ton comes on to indicate
that the motor is stopped.
Decreases the parameter
number or data value.