HOLZMANN MASCHINEN ED 300FD Manual De Instrucciones página 29

OPERATION
13.1 Before commisioning
 Lubricate all a bare machine parts with an acid-free lubricating oil.
 Function of the movable and fixed parts of control
 Lubricate the lathe from according to lubrication chart.
 Check all screws for ease of movement.
 Check that the fixing screws of the chuck are tight.
 Clamp a workpiece in the lathe chuck, lathe or turning the clamping jaws of the chuck
completely together before turning on the lathe.
13.2 Retraction prior initial
The retraction should be performed with the lowest screw speed. Let the machine at this speed
run for about 20 min. Check out irregularities, such as unusual noises, imbalances, etc. If every-
thing is in order, gradually increase the speed.
13.3 Operating
Each time before starting the spindle speed controller must be set
Chuck cover must be in lowest position!
13.4 Motor starting / stopping
To start, press the green button ˝I˝
To stop, press the red button ˝O˝
13.4.1 Setting the spindle speed
The spindle speed can be set with the spindle speed controller (16).
The adjusted spindle speed is displayed on the display spindle speed (20).
13.4.2 Setting the direction of spindle rotation
Turn on the switch spindle direction (1) in position ˝L˝ for spindle mode
counterclockwise, and in the position ˝R˝ for spindle mode clockwise.
In the position ˝ O ˝ is switched to idle
Wait at each change of direction necessarily, the machine stops, otherwise
HOLZMANN MASCHINEN GmbH
W A R N I N G
to the lowest level!
A T T E N T I O N
the machine may be damaged!
www.holzmann-maschinen.at
OPERATION
29
ED300FD