Cebora 388 Manual De Instrucciones página 22

4 – SOCKET (-) to which you should connect the earth
cable connector in MIG-MAG welding and the power
source-trolley extension connector in TIG welding.
6
2
®
3
MIG
®
SYNSTAR SYNSTAR SYNSTAR
9
INVERTER
E C O P O W E R L I N E E C O P O W E R L I N E
PFC
C O M P L IE S W IT H E N 61000-3-12 C O M P L IE S W IT H E N 61000-3-12
22/36
RS 232
TIG
16
330 TS 330 TS
Art. 388
5 – CONNECTOR
DB9 type (RS 232) connector to be used for updating the
welding programs.
6 – CONNECTOR
USB-type connector to be used for updating the welding
programs.
7 - FITTING
This is where the gas hose from the TIG torch is to be
1
connected.
8 – CONNECTOR
This is where the control cable of the Push Pull welding
torch is connected.
9 - SOCKET (+)
8
Socket where you must connect the earth cable connector
in Tig welding.
5
16 – SOCKET to which you should connect the electrode
holder in MMA welding or the TIG torch power connector
7
4 CONTROLS LOCATED ON REAR PANELS.
21
11
4
10 - FUSE HOLDER.
11 – GAS HOSE FITTING, MIG-MAG WELDING
12 – SWITCH.
Starts and stops the machine
13 – MAINS CABLE
14 – PRESSURE SWITCH CONNECTOR.
Connector which receives the cable from the pressure
switch Art.1681 (optional).
20
19
22
3300510/D