Approved Combiengines; Assembling The Unit; Mounting The Gearbox - Stihl FCS-KM Manual De Instrucciones

1
: Always walk forwards when cutting,
do not pull the unit towards you.
: Cut at a steady pace to avoid having
to make several passes.
1 = Gunning sight for cutting blade.
FCS-KM

Approved CombiEngines

Only use CombiEngines supplied by
STIHL or expressly approved by STIHL
for use with the CombiTool.
This CombiTool may be operated only in
combination with the following
CombiEngines:
STIHL KM 55, KM 55 C, KM 55 R,
KM 55 RC, KM 85, KM 85 R, KM 100,
KM 100 R, KM 110, KM 110 R
The barrier bar must be mounted on
loop-handled units.
The CombiTool may also be mounted to
STIHL brushcutters with a split boom or
drive tube (T models).
Operation of this CombiTool is therefore
also permitted on the following power
tool models:
STIHL FS 55 T, FS 55 TC, FS 55 RT,
FS 55 RTC, FS 85 T, FS 85 RT, FS 83 T
und FS 83 RT
For use of barrier bar refer to power
tool instruction manual.
English / USA

Assembling the Unit

3
2
1
1

Mounting the Gearbox

: Loosen the clamp screws (1) on the
gearbox (2) and clamp (3).
: Push the drive tube (4) through the
clamp and into the gearbox – turn
the gearbox back and forth as
necessary.
2
5
: Once the end of the drive tube is
inserted beyond the slot in the
clamp (5), push it fully home as far
as stop.
: Screw in the clamp screws as far as
stop but do not tighten down yet.
4
13