HBS x-touch 300 argon
2 Introduction
An electrosurgical unit is a generator used to transform electronic energy into high-frequency
alternating current (HF current).
If this current flows through human tissue, it creates heat which is used for cutting and for coagulation
of the tissue.
The HBS x-touch 300 argon is a versatile and compact electrosurgical unit which complies to a high
safety standard and unites economy with operative flexibility.
It offers the following application modes:
For monopolar surgical use
•
Pure cut
•
Blend cut
•
Polypectomy mode
•
Cutting in water environment (TUR)
•
Soft coagulation
•
Forced coagulation
•
Spray coagulation
•
Coagulation with argon
For bipolar use:
•
Bipolar Blend Cut
•
Bipolar Coagulation
•
Bipolar Cutting in water environment (TUR)
Benefits of the HBS x-touch 300 argon:
◼
Simple, intuitive and safe operation
◼
USB-connection for service
◼
Current terminal for optional wireless foot switch, max. 0.5 A
◼
Display-supported neutral electrode safety system helps interactively when applying the neutral
electrode
◼
Nine storage locations for individual program settings
◼
Two monopolar multifunction terminals for 3-pin standard or Martin plug, one terminal works witth
argon
◼
AutoStop function for automatic interruption of the energy supply after a certain tissue resistance
level is reached.
◼
Tone signal with scope for control of the volume, and an alarm tone in case of faults without facility
for switching off.
◼
Coloured illumination of the LCD display in red, yellow, blue to indicate different operating modes
or error statuses
◼
Facility for tracing output and impedance at the LCD display in the patient circuit on activation
◼
Worldwide application possible through connection scope from 100 to 260 volts, 50 to 60 Hz
EN
35