Accessory Tool Cleaning (Option); Operating Accessory Tools - Tennant 1610 Manual De Operador

OPERATION
3. Restorative Extraction Cleaning: Turn the solution
switch off when turning 180° and just before
coming to a stop. This will prevent un-recovered
solution on floor.
4. If excessive foam appears in the recovery tank,
pour a recommended foam control solution into
the tank.
ATTENTION: Do not allow foam to enter the float
shut-off screen, vacuum motor damage will result.
Foam will not activate the float shut-off screen.
5. Do not operate machine on inclines that exceed 3°
when cleaning or 11° while transporting.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
6. Observe the battery meter discharge level
(Figure 11). When the meter begins to flash, stop
scrubbing and transport the machine to the
recharging area. When two lights begin to flash
alternately, the scrub head will automatically raise
to the transport position. This will protect the
batteries from total discharge. Recharge batteries
immediately.
FIG. 11
7. Observe the solution tank level (Figure 12). Do not
allow the solution tank to run dry when restorative
extraction cleaning. If tank runs dry, the solution
system will need to be reprimed (See PRIMING
SOLUTION SYSTEM).
FIG. 12
8. When leaving the machine unattended, park the
machine on a level surface and remove the key.
14
Home Find... Go To..

ACCESSORY TOOL CLEANING (OPTION)

Optional accessory tools allow you to clean upholstery
and carpeted areas that the machine is unable to reach,
such as alcoves, stairs, corners and small rooms.
For a complete list of accessory tools see the
OPTIONS section in this manual.
Preparing Machine for Accessory Tool Cleaning:
1. Park the machine on a level surface and turn the
key to the off position.
2. Connect the accessory tool's solution hose to the
coupler located at the rear of the machine
(Figure 13).
FIG. 13
3. Disconnect the lower vacuum hose from the
machine and replace it with the accessory tool's
vacuum hose (Figure 14).
FIG. 14
4. Attach the accessory tool to the hoses.

Operating Accessory Tools:

1. Turn the key to the on ( I ) position.
2. Press the solution switch towards the accessory
tool symbol, off (O) position (Figure 15).
NOTE: To move the machine when using the
accessory tool, you must turn the solution switch on to
activate the drive system if the machine is set up for
ReadySpace Cleaning.
Tennant 1610 (11- -05)