Cleaning With Accessory Tools; Draining Tanks; Draining Recovery Tank; Draining Leftover Cleaning Solution - Tennant EX-SC-3840 Manual Del Operario

OPERATION
EN

CLEANING WITH ACCESSORY TOOLS

1. Disconnect vacuum hose from dome and replace
with accessory vacuum hose. Connect accessory
solution hose to quick coupler located in front of
handle (Figure 5).
FIG. 5
2. Attach desired accessory tool to hoses.
3. Turn on Vacuum/Pump switch.
4. Operate accessory tools as normal (Figure 6).
NOTE: When cleaning upholstery, always check
cleaning instructions sewn in furniture by manufacturer.
FIG. 6
5. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for five
seconds after turning off switches.
6
Home Find... Go To..

DRAINING TANKS

FOR SAFETY: When servicing machine, unplug
cord from wall outlet.
NOTE: Use different buckets to fill and drain machine
to prevent solution system clogs.

DRAINING RECOVERY TANK

1. Turn off machine and unplug power cord.
2. Turn drain hose knob counterclockwise and pull out
plug to drain (Figure 7).
FIG. 7
3. Replace drain hose knob securely.

DRAINING LEFTOVER CLEANING SOLUTION

1. Disconnect vacuum hose from recovery tank dome
and replace with .9L (3 ft) clean--out hose, supplied
with machine (Figure 8).
FIG. 8
2. Turn on Vacuum/Pump switch.
3. Remove solution tank lid and vacuum out leftover
solution.
4. Drain recovery tank.
EX- -SC- -3840 / EX- -SC- -3851 (04- -10)