Mounting The Cutting Attachment - Stihl FS 240 Manual De Instrucciones

English
Fitting the Skirt and Blade
4
4
1
5
WARNING
These parts must be fitted to the
deflector (1) when you use a mowing
head.
Slide the lower guide slot of the skirt
N
(4) onto the deflector (1) – it must
snap into position.
Push the blade (5) into the upper
N
guide slot on the skirt and line it up
with the first hole.
Insert the screw and tighten it down
N
firmly.
24
Mounting the Limit Stop
7
6
WARNING
Always fit the limit stop (6) when you use
a circular saw blade.
Position the limit stop (6) on the
N
gearbox flange.
Insert the screws (7) and tighten
N
them down firmly.
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Fitting the Thrust Plate
The machine comes standard with the
thrust plate.
1
Slip the thrust plate (1) over the
N
shaft (2).
NOTICE
The thrust plate on the gearbox is
necessary for mounting cutting tools.
FS 240, FS 240 R