Mounting The Cutting Blade - Stihl FC 70 Manual De Instrucciones

A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommended distance (A): about 6 in
(15 cm)
Slide the handle to the required
N
position.
Tighten down the star knob so that
N
the handle cannot be rotated on the
drive tube.
FC 70 C

Mounting the Cutting Blade

1
Lay the power edger on its back so
N
that the blade mounting (1) faces
up.
5
6
4
2
3
Insert the stop pin (2) or screwdriver
N
– see "Special Accessories" – into
the hole (3) as far as stop – apply
slight pressure and turn back and
forth together with the thrust
washer (4) until the pin slips into
position and blocks the shaft.
Fit the combination wrench (5) on
N
the nut (6).
Loosen and unscrew the nut
N
clockwise (left-hand thread).
Remove the thrust washer.
N
7
6
4
9
8
Place the blade (7) on the thrust
N
plate (8).
WARNING
Collar (see arrow) must engage the
blade's mounting hole.
Fit the thrust washer (4) on the
N
shaft (9) and block the shaft.
Screw the mounting nut (6) on to the
N
shaft counterclockwise and tighten
it down firmly.
English
10
7
15