Renfert SIMPLEX Manual Del Usuario página 59

Printing is complete:
♦ For easier removal of the object, the print bed is automatically lowered a little
and the print head is moved to the home position�
♦ A corresponding message is shown on the display. This can be confirmed
with "OK"�
Caution! Danger of burns!
The print head and print bed could still be hot.
Wear protective gloves!
⇒ If necessary, you can use the "AXES" menu (see Chap. 5.5) to lower the print bed further.
⇒ Remove the object from the print bed� Carefully remove the object with one hand using a slight twisting
motion while holding the print bed with the other hand. If the object is difficult to remove, use the spatula
provided�
Take care not to scratch the Kapton film.
So that removal of the object is as easy as possible, wait until the print bed has cooled.
If necessary, you can also remove the build plate from the printer to remove the object�
To do this, loosen the fixing clasps on the front right and left of the print bed and remove the build plate.
When reinserting, ensure that the build plate has been inserted in the correct end position and that the
fixing clasps are closed.
An incorrectly seated build plate can cause misprints or damage to the printer.
6 Other settings
In the "Getting started" section, the following items from the SETTINGS menu are already explained:
• Setting the language�
• Setting the temperature unit�
• Connecting to a Wi-Fi network.
• Leveling the print bed�
• Calibrating an FMS system.
Additional options in the SETTINGS menu are presented below.
6.1 Setting the date/time / resetting the operating hours meter
A video on this topic is provided under the following link
www.renfert.com/simpl-11-en
You can set the date/time and reset the operating hours meter. This function
helps you to track operating hours between maintenance work�
⇒ Select the SETTINGS menu.
⇒ Use the right arrow
⇒ Press the button with the clock icon
⇒ Use the arrows
⇒ Use the arrows
⇒ Press the lower left arrow
The operating hours meter, which can be used to track the time elapsed
between two maintenance sessions, can be reset with the reset button
The operating hours of the last reset are saved under "Last reset".
and via the QR code shown.
�
to go to page 3 (as shown here in the image).
�
/ to toggle between hour / minute / year / month / day.
/ to set the date and time�
until you are back in the main menu�
- 19 -
Fig. 38
Fig. 39
.
Fig. 40
en