Renfert SIMPLEX Manual Del Usuario página 63

7.4 Loading the filament
A video on this topic is provided under the following link
www.renfert.com/simplex-6-en
The procedure for loading a filament can be found in the "Getting Started" section.
7.5 Extrusion
A video on this topic is provided under the following link
www.renfert.com/simplex-6-en
The procedure for manual extrusion can be found in the "Getting Started" section.
7.6 Removing the filament from the extruder
A video on this topic is provided under the following link
www.renfert.com/simplex-6-en
Never remove the filament from the extruder as long as the extruder is cold. You must always
pre-heat the extruder before removing or replacing filaments. Removing the filament from a cold
extruder can damage the unit.
You do not need to remove the filament between the print runs.
When using TEMP1 and TEMP2 group filaments, always load/unload the filament with the TEMP2
setting.
⇒ Select the TEMPERATURE
⇒ Using the filament spool icon
⇒ Press the extruder icon
♦ On the display, the current temperature and the target temperature change from gray to white�
⇒ Press the lower left arrow
⇒ Select the EXTRUDER
If you select the EXTRUDER menu too early and the extruder has not yet reached
the required temperature, a warning message is shown�
⇒ Skip the warning message with the right arrow
⇒ Remove the printer cover� Pay attention to the cables of the fan�
⇒ Wait until the extruder has reached the required temperature. The current tem-
perature and the required temperature are shown at the top of the display�
⇒ Press the backwards button
press the button�
Alternatively:
⇒ Press the button for unloading the filament
ation�
With the function for unloading the filament, the filament is briefly drawn into the extruder before it is au-
tomatically unloaded. This heats up the filament in the front area slightly so that it is easier to unload and
pull out of the guiding tube�
When the cogwheels start to pull back the filament, you can safely remove the rest of the filament from
the guiding tube and connect the end of the filament to the spool for safe storage.
and via the QR code shown.
and via the QR code shown.
and via the QR code shown.
menu�
, select the filament that is currently loaded in the printer.
to start heating�
until you are back in the main menu�
menu�
�
� The cogwheel will only turn each time you
to automatically perform the oper-
- 23 -
en
Fig. 52
Fig. 53