Before Use; Priming The Circuit; Filling With Water - SOLAC CE4481 Instrucciones De Uso

ENGLISH
INSTRUCTIONS FOR USE

BEFORE USE:

Make sure that all the product's packaging has
•
been removed.
Before using this product for the first time, it is
•
advisable to test it only with water.
Before using the product for the first time, clean
•
the parts that will come into contact with food in
the manner described in the cleaning section.
Before connecting the machine, check that the
•
buttons (F, G) are not pressed, and steam con-
trol (R) is closed

PRIMING THE CIRCUIT:

This simple operation ensures optimum dis-
•
pensing and must be carried out:
When first starting:
•
When the machine has been out of use for a
•
long time (1 or 2 weeks)
After making steam
•
WHEN THE TANK HAS RUN OUT OF WATER.
Fill the receptacle taking care to observe the
•
MAX level
Connect the appliance to the mains.
•
Press the on/off switch (F) to ON position. The
•
(D) pilot light will come on
You do not have to wait for the machine to heat
•
up for this operation
Without fitting the filter holder (or with the filter
•
holder fitted, but without coffee), place a recip-
ient under the steam pipe (I)
Open the steam knob (R) by turning counter-
•
clockwise
Press the coffee switch / water (G) to ON po-
•
sition
Water will exit through the steam pipe. Wait un-
•
til approximately one cupful has exited
o finish serving, back coffee / water switch to
•
OFF position and close the steam knob (R) by
turning clockwise
This will complete the priming operation.
•

FILLING WITH WATER:

The tank must be filled with water before turn-
•
ing the appliance on.
Remove the water tank.
•
Open the cover.
•
Fill the tank taking care to observe the MAX
•
level (Fig. 1)
Close the lid.
•
Replace the tank in its housing, ensuring that
•
it is well fitted.
FILLING OF COFFEE:
Remove the filter holder.
•
Position the ground chosen coffee filter ((L ó
•
M) in the filter holder
We recommend using natural toast coffee, as
•
using roasted coffee may affect the operation
of the machine.
Fill the removable filter with ground coffee (6-7
•
g per cup to be prepared).
If you wish to make 1 coffee, use 1 filter coffee
•
and, fill the ladle (1 spoonful) and take the ca-
pacity of the measuring spoon as the measure
for one coffee until half its capacity.
For 2 coffees, use 2 cups filter (M), and put in
•
2 spoonfuls.
Next lightly press down the ground coffee with
•
the back of the spoon.
Fit the filter holder in the appliance once more.
•
Position the filter holder in the coffee assem-
•
bly by inserting the assembly downwards and
turning it from left to right until it locks.
USE
Before connecting the machine, check that the
•
buttons (F, G) are not pressed, and steam con-
trol (R) is closed
Connect the appliance to the mains.
•
Turn the appliance on using the on/off switch
•
(F)
The (D) pilot light comes on.
•
Wait until the pilot light (E) is lighting. It means
•
right temperature is reached
Place one or two preheated cups at the filter
•
holder outlet.
Press the coffee switch (G) to the ON position
•
The coffee infusion will begin to exit. When you
have obtained the desired quantity of espres-
so coffee (short or long), come back switch to
OFF position
Once serving has finished, wait a few seconds
•
and remove the cups with the coffee.
Remove the filter holder and empty the
•
grounds from it.
Wash the filter holder with running water and
•
dry it well.
Check that the removable filter is perfectly fit-
•
ted into the filter holder.
Fit the filter holder in the appliance once more.
•
EN