Argo DRY PURY EVO 11 Instrucciones De Uso página 24

APPLIANCE START-UP
Place the product on a flat and stable heat-resistant surface, at least 1 metre away from flammable or heat-sensitive
materials and 50 cm away from walls or other obstructions.
Make sure the water tank is in the correct position.
Connect the power cord to a suitable electric socket (220-240V~).
Turn the appliance on with POWER on the control panel. The unit emits a sound signal and is in standby, the colored
LED on the front panel lights up. The display shows the humidity% detected in the room, therefore set a humidity % lower
than at least 3% compared to that in the room to make the dehumidifier work.
The dehumidifier is designed to operate at ambient temperatures from + 5°C to + 35°C.
If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.
When this happens, the dehumidifier goes into defrost mode. The compressor stops, but the fan continues running.
The defrosting operation may start up and operate for some minutes; during the defrosting operation, the dehumidification
function may intermit: please don't turn off the switch or pull out the power plug of the dehumidifier.
We recommend not using the dehumidifier in room temperatures lower than 5°C.
Do not remove the tank when the unit is in operation.
If you wish to make continuous draining of condensate, follow the instructions in the dedicated paragraph.
OPERATING PRECAUTIONS
The dehumidifier starts only if the humidity level in the room is higher than 3% the set one.
The dehumidifier will continue to operate until the set humidity level is reached, except for any interruptions due to
filling the tank.
When the water tank is full, the compressor stops running immediately and dehumidification stops; the fan stops after
3 minutes. Empty the tank and reposition it: after carrying out these operations, the unit will start operating again.
ATTENTION:
After each interruption of operation, at least 3 minutes must elapse before the dehumidifier restarts: this startup delay
protects the compressor from damage.
If, on the other hand, the humidity% set is higher than that present in the room, the dehumidifier will not start.
If, after following the instructions for starting the dehumidifier, the dehumidifier does not start and the (POWER) symbol
does not light up, or the dehumidifier stops without reason, check that the condition of the plug and the power cord
are good. Once this is done, wait 10 minutes and then restart the dehumidifier.
If, even after 10 minutes, the dehumidifier does not start, or if the cable or the plug are damaged, switch off the
dehumidifier and contact a technical assistance center.
WARNING:
When the dehumidifier is running, the compressor produces heat and the appliance emits warm air into the room.
.
The room temperature will therefore tend to increase. This is completely normal
SWITCHING OFF THE DEHUMIDIFIER
To turn the dehumidifier off press the POWER button. This shuts off power to the unit.
Unplug the appliance if you do not intend to use it for some time.
V 04/23 24