Argo DRY PURY EVO 11 Instrucciones De Uso página 27

start working after 3 seconds.
On the other hand, when the humidity in the room is less than or equal to 3% of the set value, the compressor
stops while the fan continues to operate for a short period of time. The LED lights up on the control panel.
In Auto mode it is possible to adjust the fan speed with the SPEED button and the humidity level with the HUM
SET button.
• Laundry mode: Press the Mode button to activate the laundry mode, the icon lights up
panel. The unit operates continuously regardless of the humidity level, therefore it is not possible to adjust the
% of humidity and the fan speed.
• Sleep Mode: Press the Mode button on the control panel to activate this function, the icon lights up
control panel. If no selections are made on the control panel within 10 seconds, the display turns off, while
the fan speed changes from high to low. To reactivate the illumination, press any button on the control panel.
Press the Mode button again to deactivate this function.
When the humidity in the room is less than or equal to 57%, the compressor stops, while the fan continues to
operate for about 30 seconds before turning off.
When the humidity in the room is greater than or equal to 63%, the fan starts working, while the compressor
starts working after about 3 seconds.
In Sleep mode it is not possible to adjust the fan speed and the humidity level.
3. HUMIDITY BUTTON (HUM SET)
Press this button to view the % humidity in the room. Press this button again to adjust the desired humidity from
30% to 80% in 5% steps.
After making the adjustment, the set % will flash on the display for 3 seconds, thus confirming the successful setting,
the display will then go back to showing the % humidity in the room.
By holding this button down for 3 seconds, the humidity level in the room is shown on the display.
4. TIMER BUTTON
Press this button to program switching on (if the unit is off) or switching off (if the unit is on) from 0 to 24 hours.
Each time the button is pressed, the adjustment interval corresponds to 1 hour, and it is possible to view the set
time on the display. The LED
view the set time by pressing the Timer button, then the display will return to showing the humidity level detected
in the environment. To deactivate the Timer, "00" must appear on the display (it flashes 4 times), and the Timer
symbol on the control panel will switch off.
5. SPEED BUTTON
Press this button to adjust the fan speed in the following circular sequence: High - Low:
The corresponding LEDs light up on the control panel according to the selection made.
The fan speed cannot be adjusted in Laundry and Sleep modes, or when automatic defrosting is in operation.
6. CHILD LOCK BUTTON
Press this button for 3 seconds to activate the control panel lock function, the LED
up, and it is no longer possible to make selections on the control panel. Press this button again for 3 seconds to
deactivate this function, the LED goes out.
When the appliance is switched off, the child lock function is automatically deactivated.
MEMORY FUNCTION
The dehumidifier keeps the last settings selected before switching off or black out.
COLORED LED DISPLAY
On the front panel of the dehumidifier there is a LED which colors differently according to the level of humidity
detected in the environment:
Blue = Ambient humidity lower than 45%
Green = Ambient humidity between 45% and 65%
Red = Ambient humidity higher than 65%
If the following error codes E0, E2, CL, CH, LO, HI appear on the display on the control panel, the front LED will
be red (for error codes, refer to the troubleshooting section).
V 04/23
on the control panel stays on during the set time interval. It is always possible to
on the control
on the
on the control panel lights
27