Argo DRY PURY EVO 11 Instrucciones De Uso página 26

CONTINUOUS CONDENSATE DRAINAGE
The water can be continuously drained when using a PVC hose with an inner diameter of 11 mm (supplied).
Turn off the appliance and remove the plug before connecting the hose.
Connect the tube to the condensate drain hole securely and prepare a container that can hold the water. The tube
must be connected without bends or bends, to facilitate an easy drainage of the condensate, and must be positioned
at a greater height than the drain hole.
When disconnecting the hose, prepare a container to collect any residual water that may leak out of the hose.
6
1. POWER BUTTON
After connecting the appliance to the power supply, the machine goes into stand-by mode, then press this button
to turn on the dehumidifier, the red LED located under the button remains on during operation. All the LEDs on the
control panel light up, by default the fan speed is high, and the set % humidity is 50%.
Press this button to turn off the unit, the LEDs on the control panel turn off, the compressor stops while the fan
continues to run for approximately 30 seconds before turning off.
2. MODE BUTTON
Press this button to select the operating mode in the following circular sequence: Auto - Laundry - Sleep. The
corresponding LEDs on the display will light up according to your selection.
• Auto mode: Press the Mode button on the control panel to select the automatic mode, which regulates the
operation of the appliance based on the % humidity detected in the room.
When the humidity in the room is greater than or equal to 3% of the set value, the fan and the compressor
V 04/23
CONTROL PANEL
4
5
1. Power button
2. Mode button
3. Humidity button
4. Timer button
Display
3
5. Speed button
6. Lock button
2 1
26