Argo DRY PURY EVO 11 Instrucciones De Uso página 25

HOW TO ELIMINATE CONDENSATE
The water extracted from the air can be collected in the provided front tank.
When the tank is full, not inserted or not correctly inserted, the FULL TANK led turns on and the unit beeps at the
end of which the unit turns off. The LED display located on the front of the device turns red.
To switch off the appliance, press the POWER button and wait a few seconds.
1. Carefully pull out the tank, following the direction of the arrow.
2. Empty the tank and dry it thoroughly.
3. Reposition the tank
4. Press the POWER button again to turn on the unit.
If the full tank LED remains lit even after emptying the tank, check that the float, which is inside the tank, is correctly
positioned.
Make sure not to damage the float, otherwise the unit will not automatically stop working when the water tank is full,
and the water could leak out and risk wetting the floor and damage the appliance.
Do not use the drainage pipe when you want to collect the condensate in the tank, otherwise the water could come
out from the pipe.
Remove the float Empty the tank
Extract the tank following
placed in the tank
the direction of the arrows
V 04/23 25