Argo DRY PURY EVO 11 Instrucciones De Uso página 28

CARE AND MAINTENANCE
Cleaning the external surface
Warning: Always remove the plug from the socket before cleaning the dehumidifier, otherwise electric shock or
malfunction may occur.
Warning: Do not wet or immerse the dehumidifier in water otherwise electric shock may occur.
Use a soft, damp cloth to clean the outside of the dehumidifier.
Do not use solvents, petrol, xylene, talcum powder and brushes: they could damage the surface or the color of the
case.
Cleaning the water tank
It is advisable to remove the tank every two weeks to prevent the formation of mold and bacteria. Fill the water tank
with clean water and a small amount of detergent, empty and rinse it.
Double filtration system maintenance
The product is equipped with a double filtration system: anti-dust filter + active carbon filter.
Cleaning the dust filter located on the air inlet
The dust filter has an important function in retaining the main allergens.
Cleaning the dust filter should be done every two weeks of operation.
The function of the filter is to filter the dust or dirt present in the air, therefore if the filter is blocked by dust the electricity
consumption will be higher than normal.
1. Remove the filter by releasing it from its seat, following the direction of the arrow (Fig.1).
2. Gently clean the filter with a vacuum cleaner to remove dust. If necessary, wash the filter with warm soapy water
DO NOT USE ALCOHOL, BENZENE OR OTHER AGGRESSIVE PRODUCTS (Fig.2).
Leave the filter to dry naturally, then insert it back into its housing (Fig.3).
Do not use hair dryer or fire to dry the filter.
Do not use sponges or brushes to clean the filter as they can damage it.
3. Replace the filter and resume normal operation of the appliance.
Do not use the dehumidifier without the filter, because the dust could affect the efficiency of the evaporator and cause
higher energy consumption.
Fig.1 Fig.2 Fig.3
Maintenance of the additional activated carbon filter
The activated carbon filter is particularly effective in eliminating bad odours.
However, proper maintenance is required.
The filter should be replaced after approximately 600 hours of operation.
Spare parts are available at authorized technical assistance centres.
V 04/23 28