Oki LE840 Guia Del Usuario página 21

2. PRINTER SETUP
2.3.1 Loading the Media
(Cont.)
NOTE:
Be sure to set the black mark
sensor to detect the centre of the
black mark, otherwise a paper
jam or no paper error may occur.
10. Lower the Print Head Block.
11. Once the media is loaded it may be necessary to set the Media
Sensors used to detect the start position for label or tag.
Setting the Gap Sensor position
(1) Manually move the Media Sensor so that the Gap Sensor is
positioned at the centre of the labels. ( indicates the position of the
Gap Sensor).
Label Media Sensor
Setting the Black Mark Sensor position
(1) Pull about 500 mm of media out of the front of the printer, turn the
media back on itself and feed it under the Print Head past the sensor
so that the black mark can be seen from above.
(2) Manually move the Media Sensor so that the Black Mark Sensor is
in line with the centre of the black mark on the media. ( indicates
the position of the Black Mark Sensor).
Media
Media Sensor
E2- 7
2.3 Loading Supplies
Gap Sensor ( )
Black Mark
Black Mark Sensor (
Gap
)