Oki LE840 Guia Del Usuario página 76

2.PRINTER SETUP
2.11 Sensor Setting
(Cont.)
(1) REFLECT
1. Select "REFLECT" from the Sensor Adjust menu.
2. Place the tag paper to be used on the reflective sensor (Black mark
sensor) so that the sensor can detect a print area.
3. Hold down the [ENTER] for 3 seconds or more.
4. When registration of the "print area level" is completed, "Adjust
Complete" is displayed and an asterisk is shown on the right side
of the voltage.
(2) TRANS.
1. Select "TRANS." from the Sensor Adjust menu.
2. Remove some labels and place the backing paper so that the
Transmissive sensor (Gap sensor) can detect it.
3. Hold down the [ENTER] for 3 seconds or more.
4. When registration of the "label gap level" is completed, "Adjust
Complete" is displayed and an asterisk is shown on the right side
of the voltage.
(3) PE REFL./TRANS.
1. Select "PE REFL./TRANS." from the Sensor Adjust menu.
2. Remove any media from the media sensor.
3. Hold down the [ENTER] for 3 seconds or more.
4. When registration of the "no media level" is completed, "Adjust
Complete" is displayed and an asterisk is shown on the right side
of the voltage.
E2-62
2.11 Sensor Setting