Media - Oki LE840 Guia Del Usuario

7. SUPPLY SPECIFICATIONS
7. Max. effective print width
8. Effective print length
Slow-up and down area
9.
(Un-print area)
10. Paper thickness
Paper thickness
11.
can be cut
12. Max. paper roll diameter
13. Paper winding direction
14. Paper core
15 Ribbon width
NOTES:
1. To ensure print quality and print head life use only Oki Data specified media.
2. When using the peel-off at 12"/sec or more for 203dpi model, issue at 10"/sec.
When using the peel-off at 10"/sec or more for 300dpi model, issue at 8"/sec.
3. When using the disk cutter, the label length must meet the following condition:
Label length 18.0mm - (Gap length/2).
4. The Strip Module do not support the print speed of 10"/sec. or faster.
5. The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).
6. When using label stock in cut mode, be sure to cut in the gaps. Cutting labels will cause the adhesive
to stick to the cutter, which may affect the cutter performance and shorten the cutter life.
7. When the Strip Module is used on the LE840 (203 dpi model), the print speed is automatically corrected
to 10"/sec. if 12"/sec. or faster is specified.
When the Strip Module is used on the LE850 (300 dpi model), the print speed is automatically
corrected to 8"/sec. if 8"/sec. or faster is specified.
Max.
Min. 6.0
Label
Max. 1496.0
Min. 8.0
Tag
Max. 1498.0
Slow-up
Slow-down
Min.
Max.
Min.
Max.
(when the built in rewinder is used φ180)
Inside the printing side
Outside the printing side
104.0 +-0.2
15.0 17.0
1496.0 1492.0
19.0
－
1498.0
－
1.0
1.0
0.13
0.17
0.08
-
(Liner)
- 0.17
φ200
Inside diameter
φ76.2±0.3
68-112mm
E7-２
104.0 +-0.2
6.0 15.0
1496.0 1496.0
8.0
－
1498.0
－
1.0
1.0
0.13
0.17
0.08
-
(Liner)
- 0.17
φ200
(when the built in rewinder is used φ180)
Inside the printing side
Outside the printing side
Inside diameter
φ76.2±0.3
68-112mm

7.1 Media

17.0
1492.0
21.4
1498.0