Oki LE840 Guia Del Usuario página 25

2. PRINTER SETUP
2.3.2 Loading the Ribbon
(Cont.)
3. Push Ribbon along the Ribbon Shafts to a position where the ribbon is
fully to the Left against the stoppers when fitted.
4. Lower the Print Head Block and set the Ribbon Shaft Holder
Plate aligning its holes with the Ribbon Shafts.
5. Take up any slack in the ribbon. Wind the leading tape onto the
ribbon take-up roll until the ink ribbon can be seen from the
front of the printer.
6. Turn the Head Lever to Lock position to close the Print Head.
7. Close the Top Cover.
E2-11
2.3 Loading Supplies
Ribbon Shaft Holder Plate