Oki LE840 Guia Del Usuario página 88

5. TROUBLESHOOTING
5.1 Error Messages (Cont.)
Error Messages
SYSTEM ERROR
MEMORY WRITE ERR.
FORMAT ERROR
MEMORY FULL
EEPROM ERROR
RFID WRITE ERROR
RFID ERROR
LOW BATTERY
SYNTAX ERROR
PASSWORD INVALID
Please Power OFF
Other error messages
Problems/Cause
1. The printer is used in a location
where it is subject to noise or there
are power cords from other electrical
appliances near the printer or
interface cables.
2. The Power Cord of the printer is not
grounded.
3. The printer shares the same power
source with any other electrical
appliances.
4. An application software used on
your host computer has an error or
malfunction.
An error has occurred in writing to the
flash ROM/USB memory.
An error has occurred in formatting the
flash ROM/USB memory.
Saving failed because of insufficient
storage space in the flash ROM/USB
memory.
Data cannot be read-from or written-to a
backup EEPROM properly.
The printer did not succeed in writing
data onto an RFID tag after retrying
the specified number of times.
The printer cannot communicate with
the RFID module.
The voltage of the Real Time Clock
Battery is low.
While the printer is in the Download
mode for upgrading the firmware, it
receives an improper command, for
example, an Issue Command.
A wrong password was entered three
consecutive times.
A hardware or software problem may
have occurred.
1. Keep the printer and the interface
cables away from the source of noise
2. Ground the Power Cord.
3. Provide an exclusive power source for
the printer.
4. Confirm the host computer operates
properly.
Turn the printer off, and then on again.
Turn the printer off, and then on again.
Turn the printer off, and then on again.
Turn the printer off, and then on again.
Press the [RESTART] key.
Turn the printer off, and then on
again.
If you wish to keep using the same battery
even after "LOW BATTERY" error
occurs, turn off the printer and start it in
the system mode, set the date and time for
the RTC and reboot the printer. As long
as the power is on the date and time will
be correct.
Call an Oki Data authorised service
representative to replace the battery.
Turn the printer off, and then on again.
Please consult the system administrator.
Turn the printer off and then on. If this
does not solve the problem, turn off the
printer, and call an Oki Data authorised
service representative.
E5- 3
5.1 Error Messages
Solutions