AKG WMS 400 Modo De Empleo página 23

If power to the transmitter is OFF or the RF level at the antennas is zero for some other reason (e.g.,
shadow effects), the red RF LED will be lit and the audio output will be muted.
If the antennas receive RF signal, the green RF LED will be lit, the RF bargraph will indicate the field
strength of the signal received by the active antenna, and the Diversity LEDs will indicate which anten-
na is currently active.
The Audio bargraph indicates the audio level of the received signal. The Audio Level LED will flash red
to indicate audio signal clipping.
2. After approximately 5 seconds, the display will change to the last active status screen before power-
ing down.
Preset
ON LOCK
"AT 3.0 02"
LOCK
In LOCK mode, the receiver receives the transmitter signal. The receiver is electronically locked so you
cannot make any adjustments. You may, however, call up the various status screens one after the other.
The "LOCK" label is shown on the display.
• Preset: Carrier frequency shown as Subchannel number within a Frequency Group
• Frequency: Carrier frequency in MHz.
• Name: Current receiver name (comes up only if you have previously named the receiver)
In SETUP mode, the electronic lock is disabled so you can adjust all receiver parameters. The "LOCK"
label is not shown.
The following setup screens are available:
- Auto Group Setup
- Auto Channel Setup
- Preset
- HT 400 handheld transmitter input gain (TX Gain)
- Name
- Infrared data transmission (IR)
- Rehearsal (RHSL)
- Extra (X-TRA)
If your system has only a single channel, we recommend using the Auto Group Setup screen (section
3.8.1) to set the frequency.
To set frequencies for a multichannel system, use the Auto Group Setup and Auto Channel Setup screens
(section 3.8.2).
LOCK
ON
MHz
3 sec.
AUTO AUTO
LOCK GROUP CHANNEL
WMS 400
Frequency
"750.000 MHz"
for selecting the receiving frequency*
Preset Frequenz
"AT 3.0 02" "750.000 MHz"
Preset
NAME
(if in memory)
(NAME)
TX
(NAME) IR
Gain
3 Setting Up
3.7 LOCK Mode
Diagram 1: LOCK mode, toggling
between LOCK and SETUP
modes.
3.8 Setting Up the Receiver
(SETUP Mode)
*Note:
Diagram 2: Calling up setup
screens.
REHEAR EXTRA
23