Codabar; Troubleshooting; Defaults - Medtronic ACT Plus Manual Del Usuario

Codabar

Scan the "Codabar" bar code to allow the use of Codabar for scanning User and
Patient IDs.
Scan the "NOTIS Editing Enable" barcode if the UID/PID barcodes use Codabar
barcode format. The NOTIS Editing Enable barcode will remove the Start/Stop
characters imbedded in the Codabar barcodes.

Troubleshooting

Nothing happens when you follow the
operating instructions.
The laser comes on, but the symbol does not
decode.
The symbol is decoded, but not transmitted
to the host.

Defaults

If the bar code scanner does not read the bar code on the ACT Plus
packaging, reset the defaults before calling Medtronic Instrument Service. To reset
the defaults, follow this procedure, and try to rescan the packaging.
64 English
Figure 16. Enable Codabar
Figure 17. Enable NOTIS Editing
Interface/power cables are loose. Check for
loose cable connections.
The scanner is not programmed for the
correct bar code type. Be sure the scanner
is programmed to read the type of bar code
you are scanning.
The bar code symbol is unreadable. Check
the symbol to make sure it is not defaced.
Try scanning test symbols of the same bar
code type.
The distance between the scanner and bar
code is incorrect. Move the scanner closer
to the bar code.
The scanner is not programmed for the
correct bar code type. Be sure the scanner
is programmed to read the type of bar code
being scanned.
®
®
ACT Plus Operator's Manual
disposable